Assembling your Pukka
If you would like to talk with someone
about your Pukka Electric Minibike,
please contact our service center toll-free
at 1-877-855-2832.
Your Pukka Electric Minibike is partially
assembled right out of the box. To finish
assembling your Pukka you will need
to do the following:
Remove the
Pukka from the box!
Mounting the
front wheel assembly
The front wheel is located at the bottom
of the box under a strip of cardboard.
Near the front wheel is a brown box
containing the foot pegs and front axle
assembly. Remove these pieces from the
box.
1. Remove one of the axle nuts, a safety
washer, washer, and spacer from the
axle.
2. Insert the axle into the center
wheel hole and replace the spacer,
washer, safety washer, and axle nut
on the end of the axle.
3. With the axle inserted into the
wheel you are ready to mount the wheel
assembly onto the front forks. Position
the front wheel assembly so that the
tire treads point forward.
4. Slide the axle into the drop outs
of the front fork so that the drop
outs are positioned between the washer
and safety washers.
5. Insert the safety washer into
the hole in the front fork and tighten
the axle nuts with a wrench until
they are tight against the safety
washers.
6. The finished assembly should look
like the picture below.
Inserting
the foot pegs
1. The two foot pegs are located in
a brown box at the bottom of the Pukka
box. Each foot peg has a compression
button.
2. Press the button and insert the
foot peg into the tube with the button
facing downward until the button snaps
into the hole in the tube. The foot
peg cover will slide over the metal.
Inserting
the seat
1. Insert the seat post into the
seat post tube until you position
the seat at the desired height.
2. Secure the seat in place with
the seat clamp.
3. You may need to adjust the nut
on the seat clamp to
4. Adjust the seat level to the desired
position and tighten the nut on the
seat.
Attaching
the handlebar
The throttle and brake components
are already assembled on the handlebar
and on the frame. You need only attach
the handlebar to the handlebar stem.
The handlebar stem is made up of
two pieces held together by four bolts.
Remove the four bolts and the top
piece of the stem. Place the handlebar
on the stem so that it is centered
on the grooved area of the bar. Place
the top piece of the stem over the
handlebar and replace the four bolts.
1. Tighten all four of the bolts
to make prevent the handlebar from
moving during use.
|
