My Pukka won't go very
fast
If you would like to talk with someone
about your Pukka Electric Minibike,
please contact our service center toll-free
at 1-877-855-2832.
Possible causes
The possible causes of the Pukka
not having power are
Check Parental Speed
Control (PSC)
You may need to turn the PSC switch
from SLOW to FAST mode to have the
Pukka reach its top speed. Check the
PSC switch to see what speed it is
set to.
If the PSC switch is set to FAST
and your Pukka still runs slow, the
PSC may not be functioning properly.
To check whether the PSC is functioning
properly, you can hotwire the connection.
IMPORTANT Remove the
chain from your Pukka to avoid injury
to you or damage to your Pukka.
Remove the battery cover by loosening
the bolts on the bottom of the battery
tray.
Disconnect the PSC connector (brown
wires) from the PWM controller.
With the chain removed from
the sprockets, turn the ignition
key to the ON position. Connect the
brown hotwire plug from your Pukka
Troubleshooting Kit to the PSC connector
of the controller. Turn the throttle.
If the motor runs faster, the PSC
switch may not be working properly.
Check for
low battery level
You may need to recharge the batteries
in your Pukka. Plug your charger into
the side charger port of your Pukka
and then plug the charger into an
electrical outlet. Be sure to align
the groove in the charger plug with
the notch in the side charger port.
The charger light will glow red if
the battery level is below 80 percent,
yellow/orange when above 80 percent,
and green when the battery level reaches
100 percent.
The battery charger light is green, but the
batteries are not charged.
The battery charger light won't turn green.
|
